Rollers and bottom guides must match the door, track and mounting arrangement. A replacement that looks similar can have a different wheel profile, offset or fixing pattern, so identify the existing system before ordering. The manufacturer’s model data and fit instructions should determine compatibility and load limits.
Ключевые выводы
- Identify the roller and track model or measure the complete mounting geometry.
- Match glass thickness, wheel profile, mounting centres and clearances to the product specification.
- Request the manufacturer’s load rating for the complete roller set and stated door configuration.
- Do not apply a generic per-wheel load split or safety factor.
- Use a bottom guide that retains and aligns the glass as designed without binding it.
Identify the Existing Roller System
Before buying replacements, photograph the installed roller, track and mounting position. Record the manufacturer or model if known. Measure the wheel diameter and width, groove or flat profile, mounting offset, fastener centres and available adjustment. Also confirm the glass thickness and the track’s internal profile. These details help distinguish parts that look alike but do not fit.
For a model-specific example of rollers in a shower door system, see the Система двойной раздвижной двери-808. Its product page describes the roller arrangement for that model; a similar appearance does not confirm replacement compatibility.
Match the Load and Operating Conditions
Ask the supplier for the rating of the complete roller set and the door dimensions, glass construction and installation assumptions used for that rating. Do not divide panel mass by the number of wheels and treat the result as a rating: load sharing depends on the assembly and track geometry. Do not add a generic multiplier in place of the manufacturer’s data.
For a replacement, compare the original product number and published limits. If the door mass or dimensions are unknown, obtain them from the glass or enclosure supplier rather than estimating from appearance. Use the specified track, fixings and adjustment range.
Choose Wheel and Bearing Details
Wheel material, bearing design and seals are product-specific choices. Ask what materials are used, what maintenance is required and whether the supplier’s test evidence applies to the exact roller model. A claim such as “sealed bearing” should identify the design and conditions it covers; it does not by itself establish service life in every bathroom or cleaning environment.
Fit the Bottom Guide
The bottom guide should keep the panel aligned within the system’s specified clearance. Match its shape and fixing points to the enclosure and confirm that it does not pinch the glass or restrict normal travel. Do not alter the guide, track or glass to force an incompatible replacement to fit.
Replacement Checklist
- Record the existing system brand, model and part number where available.
- Measure wheel profile, dimensions, mounting centres and adjustment positions.
- Confirm track profile and actual glass thickness.
- Verify the complete set’s rating and compatible door configuration with the manufacturer.
- Check installation, cleaning and maintenance instructions for the replacement.
- Stop and ask the Zimmor Hardware team if the product identity or load information cannot be confirmed.
Часто задаваемые вопросы
Как мне определить замену ролика для дверцы душевой?
Используйте исходный номер модели, если он доступен. В противном случае запишите профиль и размеры колеса, центры крепления, регулировку, толщину стекла и профиль трека, затем подтвердите соответствие у поставщика.
Можно ли разделить вес двери на количество роликов?
No. That arithmetic does not establish the load rating of the assembly. Ask for the manufacturer’s rating for the complete set and the stated door configuration.
How do I choose a bottom guide?
Match the guide to the enclosure and glass, and confirm that it holds the panel in alignment without pinching or binding it.
Are similar-looking rollers interchangeable?
Not necessarily. Wheel profile, offset, mounting centres, track and glass thickness must match the specified system.