Shower Door Hinge Calculator

A frameless shower door usually needs two, three or four hinges. The number is set by glass weight and door width, not by the height of the handle or the price of the hinge. This calculator estimates the glass weight and returns a hinge count, a hinge spacing and a model family to start from.

Use it as a first specification, then confirm the final set against the hinge manufacturer’s load rating and the glass supplier’s weight. The rules below are conservative for residential use; commercial or high-frequency doors need a higher safety factor.

Frameless shower door drawing with caliper and hinge samples used for hinge calculation

Hinge count calculator

Enter the dimensions and press calculate.

How the count is set

Door condition Hinges Why
Up to 35 kg and 900 mm wide 2 A rated pair carries a standard residential door; two hinges also keep the swing simple.
35-50 kg, or 900-1100 mm wide 3 The middle hinge reduces glass stress and holds the door straight over time.
Over 50 kg, or over 1100 mm wide 4 Four hinges spread the load; add a stabilizer for the fixed panel and confirm anchors.

Hinge spacing

Keep the outer hinge centres about 150 mm from the top and bottom edges of the door, then divide the remaining height equally. On a 2000 mm door with two hinges, that gives centres at 150 mm and 1850 mm. With three hinges, the middle centre sits halfway between them. Always use the hinge manufacturer’s drilling template: the hole centre is not the same as the hinge body centre on every model.

Worked examples

Door Glass weight Hinges Model family
700 x 2000 mm, 6 mm 21.0 kg 2 6-8 mm adjustable
800 x 2000 mm, 8 mm 32.0 kg 2 6-8 mm adjustable or standard 8 mm
900 x 2000 mm, 10 mm 45.0 kg 3 10-12 mm heavy-duty
1100 x 2100 mm, 12 mm 69.3 kg 4 10-12 mm heavy-duty plus stabilizer

What the calculator does not cover

  • Hinge rating: a pair rated at 40 kg is not a set rated at 80 kg. Check the rating for the actual configuration and glass thickness.
  • Anchor capacity: studs, block and lightweight wall assemblies behave differently; the strongest hinge will still sag on a weak anchor.
  • Glass quality: tempered glass, hole edge quality and the glass supplier’s own limits matter. Do not drill tempered glass after tempering.
  • Use and environment: steam rooms, commercial gyms and high-frequency doors need a higher safety factor than a residential guest bathroom.

FAQ

Does door height affect hinge count?

It affects the lever arm and the spacing, and very tall doors may need an extra hinge even when the weight is moderate. The calculator uses weight and width as the primary triggers and warns above 2200 mm.

Can a 6 mm door use the same hinges as 8 mm?

Only if the hinge body is specified for 6 mm glass. Jaw width and gasket thickness differ; using an 8-12 mm hinge on 6 mm glass will not clamp correctly.

Why 150 mm from the edge?

It keeps the hinge away from the glass corner, where stress concentrates, and leaves room for the hinge body and its cover. The exact figure still comes from the manufacturer’s template.

Send the door schedule. If the result sits near a threshold, send width, height, thickness and a photo of the opening to the technical team. We will confirm the hinge set, clamp schedule and seal gaps against the drawing.