Zimmor Hardware

High Clear PC Seal-P912WS

High Clear PC Seal (P912WS) is a shower door seal that keeps water inside the enclosure, built from polycarbonate (PC).

✓ IN STOCK
Get A Quote

Send Inquiry

Please fill out the form below, we will quote you soon.

SHARE

Glass to Floor Installation

CAT.NO CLASS SIZE
P914WS 1/4″(6mm)
P956WS 5/16″(8mm)
P990WS 3/8″(10mm)
P912WS 1/2″(12mm)

The High Clear Pc Seal P912Ws is a PC shower door seal from the gasket family that keeps water inside the enclosure: profiles extruded to match glass thickness and door geometry, translucent material that disappears against clear glass, and push-on installation that requires no adhesive — the detail that makes replacement a two-minute job instead of a service call.

Specification Standard Selection note
Material PC, clear Magnetic variants for closure
Glass fit 6–12 mm profiles Measure glass, not the drawing
Install Push-on, no adhesive Trim with scissors to length
Position Bottom sweep, side jamb, strike One profile per position

The full seal family — PVC, PC and magnetic profiles by door position — is specified in the shower door seals specification guide. Reference: shower construction.

Key Features

  • Material: polycarbonate (PC) construction

Applications

  • Bottom sweep on pivot and hinged shower doors (glass-to-floor line)
  • Meeting jamb between door and fixed panel
  • Post-renovation water-leak fixes without replacing the door
  • Magnetic closure variants for doors that need a positive pull-shut
  • Replacement seals for aged or hardened gaskets on existing enclosures
  • Wholesale and OEM sourcing programs – a recurring shower door gasket line for distributors

More in this series: High Clear PC Seal-P380HJ · PVC Seal With Magnetic Stripe-5711

Installation Notes

  1. Identify the door position the seal is for – bottom sweep, side jamb or strike – one profile per position.
  2. Cut the profile to length with scissors against the actual measured glass edge.
  3. Push the seal on by hand from one end; no adhesive is required.
  4. Close the door and check the bulb/fin just kisses the floor or mating glass – trim slightly if it drags.

Frequently Asked Questions

What material is the P912WS seal?

It is extruded from polycarbonate (PC). The material stays clear against glass, resists hardening in hot wet environments, and can be trimmed with scissors.

Can one seal profile cover the whole door?

No – each gap needs its own profile: a bottom sweep for the floor line, a jamb seal for the meeting edge, a strike seal for the closing line. Mixing positions with one profile leaves gaps.

Can I combine different seal profiles on one door?

Yes – one profile per position: a bottom sweep on the floor line, a jamb seal on the meeting edge, and a strike seal at the closing line.

Do you supply the glass to floor shower seal for wholesale and OEM programs?

Yes – this model is produced in Zimmor’s Foshan factory for wholesale and OEM sourcing: custom finishes, packaging and volume pricing are confirmed per order.