High Clear PC Seal-P380HJ
High Clear PC Seal (P380HJ) is a shower door seal that keeps water inside the enclosure, built from polycarbonate (PC).
Send Inquiry
Please fill out the form below, we will quote you soon.
Glass to Glass 180°
| CAT.NO | CLASS SIZE |
| P140HJ | 1/4″(6mm) |
| P516HJ | 5/16″(8mm) |
| P380HJ | 3/8″(10mm) |
| P120HJ | 1/2″(12mm) |
The High Clear Pc Seal P380Hj is a PC shower door seal from the gasket family that keeps water inside the enclosure: profiles extruded to match glass thickness and door geometry, translucent material that disappears against clear glass, and push-on installation that requires no adhesive — the detail that makes replacement a two-minute job instead of a service call.
| Specification | Standard | Selection note |
|---|---|---|
| Material | PC, clear | Magnetic variants for closure |
| Glass fit | 6–12 mm profiles | Measure glass, not the drawing |
| Install | Push-on, no adhesive | Trim with scissors to length |
| Position | Bottom sweep, side jamb, strike | One profile per position |
The full seal family — PVC, PC and magnetic profiles by door position — is specified in the shower door seals specification guide. Reference: shower construction.
Key Features
- Material: polycarbonate (PC) construction
- Geometry: built for 180° panel angles
Applications
- Bottom sweep on pivot and hinged shower doors (glass-to-floor line)
- Meeting jamb between door and fixed panel
- Post-renovation water-leak fixes without replacing the door
- Magnetic closure variants for doors that need a positive pull-shut
- Replacement seals for aged or hardened gaskets on existing enclosures
- Wholesale and OEM sourcing programs – a recurring shower door gasket line for distributors
More in this series: High Clear PC Seal-P500HW · High Clear PC Seal-P912WS
Installation Notes
- Identify the door position the seal is for – bottom sweep, side jamb or strike – one profile per position.
- Cut the profile to length with scissors against the actual measured glass edge.
- Push the seal on by hand from one end; no adhesive is required.
- Close the door and check the bulb/fin just kisses the floor or mating glass – trim slightly if it drags.
Frequently Asked Questions
What material is the P380HJ seal?
It is extruded from polycarbonate (PC). The material stays clear against glass, resists hardening in hot wet environments, and can be trimmed with scissors.
Where exactly is this seal installed?
One profile per position: bottom sweep on the glass-to-floor line, side jamb where the door meets the fixed panel, and strike side at the closing edge. Check the profile drawing for the position this model is extruded for.
How long does a shower door seal last?
Seals age with heat, UV and cleaning chemicals. When the fin stops wiping water cleanly, swap the profile – push-on fitting makes that a two-minute job.
Do you supply the pc shower door seal for wholesale and OEM programs?
Yes – this model is produced in Zimmor’s Foshan factory for wholesale and OEM sourcing: custom finishes, packaging and volume pricing are confirmed per order.
Need help selecting? Read the shower door bottom sweep guide before ordering this model, or compare the full seal and header range.









